wiki:id:intact_automation
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
wiki:id:intact_automation [2023/08/15 08:43] – goldy | wiki:id:intact_automation [2024/02/22 12:24] (current) – goldy | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Intact.Simulation for Automation ====== | + | ====== Intact.Simulation for Automation |
- | See documentation here: https:// | + | ===== Intact.Simulation for Automation is available using Command Line Interface. ===== |
- | + | <WRAP center round tip 60%> | |
- | Intact.Simulation for Automation is available using Command Line Interface. | + | Example Blog: [[https:// |
+ | | Automated Simulation of 300 Design Submissions to GE Bracket Challenge]] | ||
+ | </ | ||
{{ : | {{ : | ||
- | Example Blog: [[https:// | + | ====== Instructions ====== |
- | | Automated Simulation of 300 Design Submissions to GE Bracket Challenge]] | + | |
+ | |||
+ | - [[https:// | ||
+ | - Our CLI executable is //C:\Program Files\Intact.Simulation\intact.exe// | ||
+ | | ||
+ | | ||
+ | < | ||
+ | {{ : | ||
+ | </ | ||
+ | |||
+ | |||
+ | ====== Typical workflow ====== | ||
+ | |||
+ | <WRAP center round box 100%> | ||
+ | - Set up the input Json and provide the geometry file (.VDB, .PLY, .STL) and boundary condition faces (.STL, .PLY) | ||
+ | - Call intact cli //$ intact | ||
+ | - A successful run will result into a *_samples.vtu result file | ||
+ | - You can visualize the result view in Paraview (an opensource program, see more in )[[https:// | ||
+ | - Also see the CLI Documentation to resample the saved solution on custom points | ||
+ | </ |
wiki/id/intact_automation.1692110607.txt.gz · Last modified: 2023/08/15 08:43 by goldy