Differences

This shows you the differences between two versions of the page.

--- wiki:sns:intactgh:results [2023/12/06 11:36] – [Simulation Reader] goldy
+++ wiki:sns:intactgh:results [2024/02/12 08:12] – goldy
@@ Line 1: / Line 1: @@
 ~~NOTOC~~
 ======Results and Visualization ======
+===== Visualize =====
 <WRAP group>
 <WRAP half column>
-All Results can be viewed using the Visualization Block.
+All Results can be viewed using the **Visualize** Block.
 The visualization block accepts the following three inputs:
@@ Line 14: / Line 15: @@
 {{ :wiki:sns:intactgh:viz_block.png?200}}
 </WRAP>
+</WRAP>
+<WRAP center round info 60%>
+Scroll down to Visualization Hint for demo video.
 </WRAP>
@@ Line 28: / Line 32: @@
 Figure below has a simple example that show how to use Read Sim block to visualize old simulations from a Project folder.
-{{:wiki:sns:intactgh:read_sim_example.png}}
+{{ :wiki:sns:intactgh:read_sim_example.png |}}
 </WRAP>
@@ Line 48: / Line 52: @@
 <WRAP group>
 <WRAP half column>
-The sampler block samples a solution at a set of points.  It requires 2 inputs:
+The sampler block samples a solution at a set of points.  It has 3 inputs:
   * the solution to be sampled
   * list of points in (or on) the geometry where the solution is sampled
+  * a material input in the case of an **assembly of components with different materials**.
+<WRAP center round important 80%>
+Note that using incorrect material will yield wrong results.
+</WRAP>
+.
 The outputs are as follows:
   * a list of the names of the solution quantities
   * a tree of solution values at the input points
   * a list of the corresponding points where the sampling occurred (these points may or may not correspond identically with the input points)
-<WRAP center round box 60%>
+<WRAP center round box 80%>
 📌 See an example problem: [[wiki:sns:intactgh:ex_7|Sampling Custom Points]]
 </WRAP>
@@ Line 66: / Line 75: @@
 ===== Visualization Hints =====
-** Z-fighting ** Visualization of results is best performed with the original geometry on a hidden layer or in Rhino viewports that are in wireframe mode.  This avoids the z-fighting that occurs when Rhino draws both the original geometry and the simulation results.
+Note: you may have to hide other geometries that interfere with the result visualization (** Z-fighting **) and also use Wireframe mode. Other geometries may have been added through Grasshopper (hide by **turning off Preview** for the GH block) or through Rhino (using Rhino's **Hide** command)
+{{ :wiki:sns:intactgh:8-_visualize_results.mp4?750 |}}
+Usage of deflection scale to animate the part deflection.
+  * Scale the deformation to see the deflected shape
+{{ :wiki:sns:intactgh:9-_post_process_deflection_.mp4?750 |}}
 ** Previews ** In the same vein, the inputs to the simulation (components, loads, and restraints) can have their previews turned off to avoid their geometry interfering with the visualization of results.