Differences

This shows you the differences between two versions of the page.

--- wiki:sns:intactgh:getting_started [2023/05/12 08:42] – goldy
+++ wiki:sns:intactgh:getting_started [2024/02/05 08:45] (current) – [Quick Start Guide] goldy
@@ Line 1: / Line 1: @@
 ======Getting Started======
-  *[[wiki:sns:intactgh:installation|Installation]]
+  *[[wiki:sns:intactgh:installation|Installation]] & [[wiki:sns:intactgh:activating_migrating_license|Activating/Migrating License]]
   *[[wiki:sns:intactgh:supported_rhino_models|Supported Rhino Models]]
   *[[wiki:sns:intactgh:basic_operation|Basic Operation]]
@@ Line 6: / Line 6: @@
 ===== Quick Start Guide =====
-See the following videos to get started with Intact.Simulation Grasshopper Plugin quickly.
+See the following videos to get started with Intact.Simulation Grasshopper Plugin quickly.\\
+** Note: the videos utilize Rhino 7 so there may be some minor discrepancies, but the workflow remains consistent**
 Download **demo files** using the link below to use our example.
-{{ :wiki:sns:intactgh:intact_simulation_demo_files.zip |Link to download}}
+{{ :wiki:sns:intactgh:intact_simulation_demo_files.zip |Link to download}} \\
+{{ :wiki:sns:intactgh:intact_simulation_demo_files_rhino7.zip |* Legacy * Link to download (for Rhino 7)}}
 ==== A. Setting Up Your First Simulation ====
@@ Line 36: / Line 38: @@
   * Create a component from the design geometry and specify the appropriate material
+  * Note you can also add blocks by double clicking on the canvas (See [[wiki:sns:intactgh:tips_and_tricks|Tips and Tricks]])
 {{ :wiki:sns:intactgh:4-_component_setup.mp4?750 |}}
 === Step 5: Specify Boundary Condition ===
@@ Line 46: / Line 49: @@
   * Specify the faces that are loaded as well as load type and load magnitude (pressure load in this case)
+  * Loads are in MKS unit system (Pa for Pressure)
 {{ :wiki:sns:intactgh:6-_apply_load.mp4?750 |}}
 === Step 6: Specify Simulation Resolution ===