Differences

This shows you the differences between two versions of the page.

--- wiki:sns:intactgh:supported_rhino_models [2022/07/25 08:46] – created - external edit 127.0.0.1
+++ wiki:sns:intactgh:supported_rhino_models [2024/01/29 11:45] (current) – goldy
@@ Line 10: / Line 10: @@
 ===== Polysurfaces =====
-{{:wiki:sns:snspro:sns52.png?400|}}
+{{:wiki:sns:snspro:sns52.png|}}
 If the polysurface is a proper solid the listing should show:
@@ Line 21: / Line 21: @@
 ===== Extrusions =====
-{{:wiki:sns:snspro:sns53.png?400|}}
+{{:wiki:sns:snspro:sns53.png|}}
 If the extrusion object is a proper solid the listing should show:
@@ Line 34: / Line 34: @@
 ===== Meshes =====
-{{:wiki:sns:snspro:sns54.png?400|}}
+{{:wiki:sns:snspro:sns54.png|}}
 If the mesh is a proper solid the listing should show:
@@ Line 45: / Line 45: @@
 In **addition**, Intact.Simulation for Grasshopper can also work with assemblies of multiple components (solids) in bonded contact with each component comprised of different material. For example, the figure below shows such an assembly:
-{{:wiki:sns:snspro:sns55.png?400|}}
+{{:wiki:sns:snspro:sns55.png|}}