Differences

This shows you the differences between two versions of the page.

--- wiki:sns:intactgh:thermal_bc [2023/05/15 10:17] – paul
+++ wiki:sns:intactgh:thermal_bc [2025/08/13 11:28] (current) – goldy
@@ Line 4: / Line 4: @@
 ====== Thermal Boundary Conditions ======
 <WRAP half column>
-Thermal boundary conditions are applied to faces of the components participating in the simulation by connecting to the boundary condition input on the thermal solver component
+Thermal boundary conditions are applied to faces of the components participating in the simulation by connecting to the boundary condition input on the thermal solver component.
+⚠️Also, refer to [[wiki:sns:intactgh:lists|Using lists for Intact components]] for explanation of how list input works with Load Blocks.
 </WRAP>
 <WRAP half column>
-{{ :wiki:sns:intactgh:thermal_boundary_condition.png?200|}}
+{{ :wiki:sns:intactgh:thermal_solver_block_surface.png?200 }}
 </WRAP>
@@ Line 17: / Line 19: @@
 A Temperature boundary condition requires two inputs:
-  * the geometry of the surfaces where the temperature is fixed
+  * G: the geometry of the surfaces where the temperature is fixed
-  * the magnitude of the temperature in MKS units
+  * T: the magnitude of the temperature
 </WRAP>
 <WRAP half column>
-{{ :wiki:sns:intactgh:temperaturebc.png?200|}}
+{{ :wiki:sns:intactgh:temperaturebc.png?200 }}
 </WRAP>
@@ Line 30: / Line 32: @@
 A thermal convection boundary condition requires three inputs:
-  * the geometry of the surfaces where the convection is specified.
+  * G: the geometry of the surfaces where the convection is specified.
-  * the coefficient of convection in MKS units
+  * C: the coefficient of convection
-  * the temperature of the surrounding medium in MKS units
+  * Te: the temperature of the surrounding medium
 </WRAP>
 <WRAP half column>
-{{ :wiki:sns:intactgh:convectionbc.png?200|}}
+{{ :wiki:sns:intactgh:convectionbc.png?200 }}
 </WRAP>
@@ Line 45: / Line 47: @@
 A surface thermal flux requires two inputs:
-  * the geometry of the surfaces where the heat flux is applied
+  * G: the geometry of the surfaces where the heat flux is applied
-  * the magnitude of the heat flux in MKS units
+  * HF: the magnitude of the heat flux
 </WRAP>
 <WRAP half column>
-{{ :wiki:sns:intactgh:thermalfluxbc.png?200|}}
+{{ :wiki:sns:intactgh:thermalfluxbc.png?200 }}
 </WRAP>