Differences

This shows you the differences between two versions of the page.

--- wiki:sns:sns2014:basic_operation [2017/07/12 14:42] – created claire
+++ wiki:sns:sns2014:basic_operation [2017/07/13 12:36] (current) – claire
@@ Line 1: / Line 1: @@
 ====== Basic Operation ======
-In Rhino, type **SnS** in the Rhino’s command prompt window and select a solid model on which structural analysis is to be performed. Refer to section on[[models|Supported Models]] on how to determine if the Rhino model is a valid solid.
+In Rhino, type **SnS** in the Rhino’s command prompt window and select a solid model on which structural analysis is to be performed. Refer to section on [[wiki:sns:sns2014:supported_rhino_models|Supported Rhino Models]] on how to determine if the Rhino model is a valid solid.
 A typical sequence of commands to perform structural test on the solid model is as follows:
-  - Select the material, standard or **Custom**
+  - Select the [[wiki:sns:sns2014:materials|material]], standard or **Custom**
-  - Apply the restraints, **Edit** to partially restrain
+  - Apply the [[wiki:sns:sns2014:restraints|restraints]], **Edit** to partially restrain
-  - Apply the loads, **Edit** to modify
+  - Apply the [[wiki:sns:sns2014:loads|loads]], **Edit** to modify
   - Click **Go**
-  - **View** the results (strength, weakness, stresses, deformations)
+  - **View** the [[wiki:sns:sns2014:results|results]] (strength, weakness, stresses, deformations)
-  - Click **Bake** to save the deformed shape
+  - Click **[[wiki:sns:sns2014:bake_deformed_geometry|Bake]]** to save the deformed shape
-  - Click **Report** to generate web-ready reports
+  - Click **[[wiki:sns:sns2014:report|Report]]** to generate web-ready reports
-The commands are initiated by clicking on the corresponding buttons in the Specify and View tabs of Scan&Solve™ as explained in the summary of [[controls|Controls]].
+The commands are initiated by clicking on the corresponding buttons in the Specify and View tabs of Scan&Solve™ as explained in the summary of [[wiki:sns:sns2014:controls|Controls]].