Differences

This shows you the differences between two versions of the page.

--- wiki:sns:sns2014:supported_rhino_models [2017/07/12 14:40] – claire
+++ wiki:sns:sns2014:supported_rhino_models [2017/07/13 14:03] (current) – claire
@@ Line 1: / Line 1: @@
+~~CLOSETOC~~
+{{TOC:wide}}
+\\
 ====== Valid Rhino Models for Scan&Solve Pro ======
 Scan&Solve works with Rhino **solids** (polysurfaces), **extrusions**, and **meshes** that are valid representations of solid shapes. To determine if a model is a proper solid, use the Rhino command "What" on the geometry. It should report something similar to the following.
-==== Polysurfaces ====
+===== Polysurfaces =====
 {{:wiki:sns:snspro:sns52.png?400|}}
@@ Line 14: / Line 17: @@
 as highlighted above. If your model is not recognized as solid, use the tools under Rhino's [Solid] menu to make it into a solid that Scan&Solve can use.
-==== Extrusions ====
+===== Extrusions =====
 {{:wiki:sns:snspro:sns53.png?400|}}
@@ Line 26: / Line 29: @@
 as highlighted above. If your models is missing end caps, use Rhino's tools to close the open ends. Then use Rhino's **[Join]** command to join the surfaces together to form a closed valid polysurface on which Scan&Solve can operate.
-==== Meshes ====
+===== Meshes =====
 {{:wiki:sns:snspro:sns54.png?400|}}