User Tools

Site Tools

wiki:sns:snsscript:getting_started

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
wiki:sns:snsscript:getting_started [2017/07/14 14:02] – clairewiki:sns:snsscript:getting_started [2017/07/14 14:03] (current) – claire
Line 1: Line 1:
 +~~NOTOC~~
 ======Getting Started====== ======Getting Started======
  
Line 20: Line 21:
 If a Rhino solid already has loads and restraints set up, SnSScript will use that scenario when it is called to run on that solid.  Setting up the SnSScript scenario this way can often be faster than fully automating the creation of the scenario through the command line. If a Rhino solid already has loads and restraints set up, SnSScript will use that scenario when it is called to run on that solid.  Setting up the SnSScript scenario this way can often be faster than fully automating the creation of the scenario through the command line.
  
- 
-**Tools > RhinoScript > Edit...** 
  
 Run the following examples by cutting and pasting the code from your browser into the RhinoScript editor. Run the following examples by cutting and pasting the code from your browser into the RhinoScript editor.
------+
 ====Basic Examples==== ====Basic Examples====
 [[Short Example]]\\ [[Short Example]]\\
wiki/sns/snsscript/getting_started.1500062526.txt.gz · Last modified: 2017/07/14 14:02 by claire