Differences

This shows you the differences between two versions of the page.

--- wiki:sns:intactgh:installation [2024/02/06 15:25] – goldy
+++ wiki:sns:intactgh:installation [2024/02/07 09:46] – graham
@@ Line 20: / Line 20: @@
 <WRAP center round box 90%>
   * Plugin update for **Rhino 8** (will not work with Rhino 7)
-  * **Auto** and Manual mode to the solvers: a new Boolean input to each solver to control if it solves automatically or requires manual intervention
+  * **Auto** and Manual mode to the solvers: a new Boolean input to each solver to control if it solves automatically or requires manual intervention. See [[wiki:sns:intactgh:automation|]] for more information and [[wiki:sns:intactgh:beginner_ex_6|Ex-6: Automation of a variable geometry heat sink]] for example files.
-  * Support for **List** input for easily specifying a large number of loads, or composite plies with different orientations, for example.
+  * Support for **List** input for easily specifying a large number of loads, or composite plies with different orientations, for example. More information can be seen at [[wiki:sns:intactgh:lists|Using lists for Intact components]].
-  * Allow material as input to sampler block, to allow sampling multi-material assemblies.
+  * Allow material as input to sampler block, to allow sampling multi-material assemblies. For up to date information on this component block see [[wiki:sns:intactgh:results|Results and Visualization]].
   * When reading an archived solution, display glyphs to indicate the boundary conditions
   * Pretty print simulation scenario configuration for archived solutions